Table of Contents
Advertisement
2.10.
Picture settings and guide lines
The picture settings are adjusted by the 3 buttons on the video-interface. Press the MENU
button to open the OSD settings menu or to switch to the next menu item. Press UP and
DOWN will change the selected value. The buttons are embedded in the housing to avoid
accidental changes during or after installation. Picture settings must be done separately for
AV1 and AV2 while the corresponding input is selected and visible on the monitor. The rear-
view camera settings conceivably have to be done in AV 2.
Note: The OSD menu is only shown when a working video source is connected to the
selected video-input of the interface.
The following settings are available:
Contrast
Brightness
Saturation
Position H / V (no function)
IR-AV1/AV2 (no function)
Guide-CNTRL (guide lines ON/OFF)
Guide L/R (to move the guide lines)
PDC CNTRL (ON/OFF) (Factory PDC ON/OFF)
CAR-TYPE (no function)
Note:
To adjust the reverse picture, engage the reverse gear.
To adjust the guide lines, move the steering wheel to see the changes.
If there is no communication between interface and the vehicle`s CAN-bus (several vehicles
aren't compatible), the reverse gear guide-lines can`t be shown during the vehicle's
operation, even if they once appear after having switched the system to powerless!
Version 06.03.2020
HW CAM(V31),(V22)
RL2-MMI3G-Q3/GW
Advertisement
Table of Contents
