Can-Box; Installation; Place Of Installation; Place Of Installation - Daughter Pcb - r.LiNK RL2-RLINK Manual

1.3.2. CAN-box

The CAN-box reads digital signals from the CAN-bus and converts them for the video-
interface.

2. Installation

Switch off ignition and disconnect the vehicle's battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle to "Sleep-Mode". In case it does not succeed,
disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
2.1.

Place of installation

2.1.1. Place of installation – video interface und CAN-Bus box
The interface boxes shall be installed behind the vehicle`s head-unit or the glove
department, depending on equipment and space.

2.1.2. Place of installation - daughter PCB

The interface's daughter PCB is prepared to be installed between the head unit's housing
and the monitor panel.
For this purpose the housing of head-unit have to be opened.
Version 22.08.2018 HW CAM(V31)/(V22) RL2-RLINK