Supermicro H13DSG-O-CPU User Manual page 39

Front Panel Connector (JF1)
JF1 contains various buttons and indicators that are normally located on a control panel at the
front of the chassis. The JF1 connector is designed specifically for use with the Supermicro
chassis.
TPM Header/Port 80 Connector
A Trusted Platform Module (TPM)/Port 80 header is located at JTPM1 to provide TPM support
and Port 80 connection. Use this header to enhance system performance and data security.
Refer to the table below for pin definitions. Please go to the following link for more information
on the TPM: http://www.supermicro.com/manuals/other/TPM.pdf.
SATA Ports
The H13DSG-O-CPU has two SATA 3.0 ports (SATA0~1) that are supported by ASMEDIA
ASM1061.
Trusted Platform Module Header
Pin Definitions
Pin# Definition Pin#
1 +3.3V 2
3 RESET# 4
5 SPI_CLK 6
7 SPI_MOSI 8
9 +3.3V Stdby 10
39
Chapter 2: Installation
Definition
SPI_CS#
SPI_MISO
GND
NC
SPI_IRQ#