Table of Contents
Advertisement
6-10 Installing and Replacing the Adapter Card
Adapter cards (Figure 6-14) provide hot-swappable functionality to the chassis.
Node Drawer
Removing the Adapter Card
1. Remove the node from the back of the chassis. It is not necessary to power
down the system.
2. Remove the ten screws securing the adapter card to the drawer and set them
aside for later use.
3. Remove the adapter card from the drawer.
Installing the Adapter Card
1. Make sure the serverboard has been installed properly in the node drawer
before installing the adapter card
2. Place the adapter card in the drawer, aligning the holes in the adapter card
with the holes in the drawer.
3. Secure the adapter card to the drawer, using the ten M3 flathead screws
which were previously set aside.
4. Return the drawer to the closed position in the chassis.
Figure 6-14. Adapter Card Installation
Adapter Card
6-15
Chapter 6: Advanced Chassis Setup
Ten Screws
Advertisement
Table of Contents
