Supero SUPERSERVER 2027TR-D70RF User Manual page 117

Network Stack
Select Enabled enable PXE (Preboot Execution Environment) or UEFI (Unified
Extensible Firmware Interface) for network stack support. The options are Enabled
and Disabled.
IPv4 PXE Support (Available when Network Stack is set to Enabled)
Set this item to Enabled to activate IPv4 PXE Support. The options are Enabled
and Disabled.
IPv6 PXE Support (Available when Network Stack is set to Enabled)
Set this item to Enabled to activate IPv6 PXE Support. The options are Enabled
and Disabled.
Super IO Configuration
Super IO Chip: This item displays the Super IO chip used in the motherboard.
Serial Port Attribute
Use this feature to select the attribute for this serial port. The options are COM/
SOL (Serial On LAN), and BMC.
COM Configuration
Serial Port
Select Enabled to enable a serial port specified by the user. The options are
Enabled and Disabled.
Device Settings
This item displays the settings of Serial Port 1 (COM).
Change Settings
This option specifies the base I/O port address and the Interrupt Request
address of Serial Port 1 (COM). Select Disabled to prevent the serial port from
accessing any system resources. When this option is set to Disabled, the serial
port becomes unavailable. The options are Auto, IO=3F8h; IRQ=4; IO=3F8h;
IRQ=3; IO=2F8h; IRQ=3; IO=3E8h; IRQ=5; IO=2E8h; IRQ=7; IO=3F8h; IRQ=3,
4, 5, 6, 7, 10, 11, 12; IO=2F8h; IRQ=3, 4, 5, 6, 7, 10, 11, 12; IO=3E8h; IRQ=3,
4, 5, 6, 7, 10, 11, 12; and IO=2E8h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;
7-17
Chapter 7: BIOS