Switching Audio Input; Using The Built-In Microphone - Panasonic P2HD AG-HPX250EJ Operating Instructions Manual

Switching audio input

During shooting, you can record up to four
channels of sound. You can also switch the input
sound to be recorded on each of the channels to
the built-in microphones, external microphones or
audio equipment connected to camera-recorder.
(See table below.)
CH1
SELECT CH1 recording
switch
INT (L) Built-in microphone
Lch
INPUT1 INPUT1 switch
selection is valid
(LINE/MIC select)
INPUT2 INPUT2 switch
selection is valid
(LINE/MIC select)
CH2
SELECT CH2 recording
switch
INT (R) Built-in microphone
Rch
INPUT2 INPUT2 switch
selection is valid
(LINE/MIC select)
However, the following restrictions apply depending
on the format used.
• Refer to the section "Recording format list" (Page
161) recording format.
When the AVC-I100, AVC-I50, DVCPROHD or
DVCPRO50 format is used:
The recording mode is fixed at 4-channel
recording.
When the DVCPRO or DV format is used:
Either 2 or 4 channels can be selected using 25M
REC CH SEL on the setting menu AUDIO SETUP
screen.
52
CH3 recording
INPUT1 switch
selection is valid
(LINE/MIC select)
Built-in microphone
Lch
Built-in microphone
Lch
CH4 recording
INPUT2 switch
selection is valid
(LINE/MIC select)
Built-in microphone
Rch
INPUT1 LINE/MIC switch
INPUT1 switch
(MIC POWER +48V)
INPUT2 LINE/MIC switch
INPUT2 switch
(MIC POWER +48V)
AUDIO CH2 SELECT switch
AUDIO CH1
SELECT switch

Using the built-in microphone

1
Switch the AUDIO CH1 SELECT switch to
INT (L).
• Audio from the built-in microphone Lch is
recorded to audio channel 1.
2
Switch the AUDIO CH2 SELECT switch to
INT (R).
• Audio from the built-in microphone Rch is
recorded to audio channel 2.
AUDIO INPUT 1/2 terminal