Audio Input; Switching The Audio Input - Panasonic AG-CX10 Operating Instructions Manual

Audio input

The unit can record 2 channels of audio.
When the handle unit (supplied) is attached to the unit, you can connect audio equipment or an external microphone to the <INPUT 1>/<INPUT 2>
terminals.
The audio to input to each channel can be switched to the built-in microphone, an external microphone, or a connected audio device.

Switching the audio input

∫ Audio recording format
The audio recording format such as compression format varies depending on the [FILE FORMAT].
[FILE FORMAT]
*1
[P2]
[MOV]
[MP4]
[AVCHD]
*1 Available for setting when using
When the setting in the [SYSTEM] menu → [REC FORMAT] is the following, this will be 48 kHz/16 bit.
*2
j [1080-59.94p/AVC-G12], [1080-50.00p/AVC-G12], [1080-59.94i/AVC-G12], [1080-50.00i/AVC-G12], [720-59.94p/AVC-G12], [720-50.00p/AVC-G12]
When the setting in the [SYSTEM] menu → [REC FORMAT] is the following, 48 kHz/16 bit or 48 kHz/24 bit can be selected in the [SYSTEM] menu → [AUDIO
SAMPLE RES.].
j [1080-59.94i/AVC-I100], [1080-50.00i/AVC-I100], [720-59.94p/AVC-I100], [720-50.00p/AVC-I100], [1080-59.94i/AVC-I50], [1080-50.00i/AVC-I50],
[720-59.94p/AVC-I50], [720-50.00p/AVC-I50]
∫ Selecting audio input signals (When the handle unit is attached to the unit)
Selects the audio signal to record in the audio channel 1/audio channel 2.

CH1 SELECT switch
A
CH2 SELECT switch
B
CH1 SELECT switch setting
<INT/MIC (L)>
<INPUT1>
Chapter 5 Shooting — Audio input
Recording format
Linear PCM (LPCM)
Linear PCM (LPCM)
AAC
™
Dolby Audio
.
CX10

CH2 SELECT switch setting
<INT/MIC (R)>
<INPUT1>
<INPUT2>
<INT/MIC (R)>
<INPUT1>
<INPUT2>
48 kHz/24 bit
48 kHz/24 bit
48 kHz/16 bit
48 kHz/16 bit
Input signal to be recorded
Audio channel 1
Built-in microphone <L>/<MIC> terminal
Lch
Built-in microphone <L>/<MIC> terminal
Lch
Built-in microphone <L>/<MIC> terminal
Lch
<INPUT 1> terminal
<INPUT 1> terminal
<INPUT 1> terminal
- 129 -
Sampling rate/bit
*2
Audio channel 2
Built-in microphone <R>/<MIC> terminal
Rch
<INPUT 1> terminal
<INPUT 2> terminal
Built-in microphone <R>/<MIC> terminal
Rch
<INPUT 1> terminal
<INPUT 2> terminal