Table of Contents
Advertisement
RECORDING SETUP screen (continued)
Item
TC PRESET
Sets the initial time code.
• Set the frame value to 0 or multiples of 5 when shooting/
recording is set to 24P, 24PA, or 24PN.
If any other value, the recorded time code will mis-
match.
UB MODE
Sets the data recorded in the camera-recorder user bits.
USER, TIME, DATE, EXT, TCG, FRM. RATE
"Setting user bits" (Page 62)
UB PRESET
Sets the user information. Select USER in UB MODE.
ONE CLIP REC
Sets one-clip recording mode.
ON, OFF
"One-clip recording (ONE CLIP REC)" (Page 47)
START TEXT
Sets whether to automatically add a text memo at the
MEMO
recording start position each time you start recording.
ON, OFF
TIME STAMP
Determines whether or not date and time information will
be superimposed on the image.
ON:
Superimposes date and time information on the image.
OFF:
Does not superimpose date and time information on the
image.
<Note>
When DATE/TIME on the DISPLAY SETUP screen
is set to OFF, the date and time information is not
superimposed.
___indicates the factory setting.
Setting
Notes
• Not available in the following
conditions.
· W hen REC FUNCTION is
set to something other than
NORMAL.
· When VFR is set to ON.
• Not available when REC
FUNCTION is set to something
other than NORMAL.
• The text memo that is added
when this is set to ON indicates
the recording start position.
For details on recording the text
memo as text information, refer
to "Setting of clip meta data"
(Page 87).
139
Advertisement
Table of Contents
