Table of Contents
Advertisement
Setup menu list (continued)
SW MODE screen (continued)
Item
USER MAIN
USER1
USER2
USER3
USER4
MF ASSIST
FOCUS ASSIST
WFM
___indicates the factory setting.
136
Sets the function assigned to the USER MAIN button.
SPOTLIGHT, BACKLIGHT, ATW, ATWLOCK, S.GAIN,
D.ZOOM, Y GET, DRS, TEXT MEMO, SLOT SEL,
SHOT MARK, MAG A. LVL, LVL METER, PRE REC,
WFM, LAST CLIP, FBC, LCD B.L
"Using the USER buttons" (Page 39)
Sets a function assigned to the USER1 button.
The functions that can be assigned to this button are the
same as for the USER MAIN button.
BACKLIGHT (factory default setting)
"Using the USER buttons" (Page 39)
Sets a function assigned to the USER2 button.
The functions that can be assigned to this button are the
same as for the USER MAIN button.
TEXT MEMO (factory default setting)
"Using the USER buttons" (Page 39)
Sets a function assigned to the USER3 button.
The functions that can be assigned to this button are the
same as for the USER MAIN button.
DRS (factory default setting)
"Using the USER buttons" (Page 39)
Sets a function assigned to the USER4 button.
The functions that can be assigned to this button are the
same as for the USER MAIN button.
SLOT SEL
"Using the USER buttons" (Page 39)
Automatically sets the last focus during manual focusing.
ON:
Automatically sets the last focus.
• The focus may not be set correctly if the last focus
differs considerably from the manually set focus.
• You cannot operate using the remote control connected
to the CAM REMOTE jack.
OFF:
The focus is not adjusted automatically.
Sets the function assigned to the FOCUS ASSIST button.
IN RED:
The image contour has red edges.
EXPAND:
The screen center of the LCD monitor is enlarged.
Selects the type of waveform to be displayed on the LCD
monitor when the WFM button is pressed.
WAVE:
Displays a waveform.
VECTOR:
Vectorscope display
WAVE/VECT:
Each press of the button, switches the settings in the
following order:
OFF → WAVE (waveform) → VECTOR → OFF
Setting
Notes
Advertisement
Table of Contents
