Motorola C6 Instructions Manual page 8

Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process for
all the handsets and chargers.
1. Plug the power adaptor with red connector into the socket marked
underside of the charger and plug the other end into the mains power wall
socket.
2. Remove the battery cover from the back of the handset and insert the 2
x AAA NiMH rechargeable batteries supplied. Please note the '+' and '-'
markings inside the battery compartment and insert in the correct direction.
3. Slide the battery cover back into place.
4. If you are charging the batteries for the first time, place the handset on the
charger to charge for at least 16 hours continuously.
5. When the handset is fully charged,
The display will show the time and handset number (e.g. 2) to indicate that it is
registered to the base.
Important
Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA Ni-MH
550mAh rechargeable batteries) supplied with your C6. Please do not use alkaline
or nonrechargeable batteries. It may cause permanent damage to the product
and void the warranty.
Battery low warning
If icon flashes on the display and you hear a warning beep every minute
during a call, you will need to recharge the handset before you can use it again.
When charging,
will stop.
8
icon will scroll on the display. Once fully charged scrolling
icon will appear steady on the display.
on the
Getting started