Related Manuals for Elsema iS3000
Summary of Contents for Elsema iS3000
- Page 1 HIGH SPEED SLIDING GATE OPENER : iS2000/iS3000 Model Elsema’s Eclipse Control Card ® USER MANUAL...
- Page 2 Always incorporate the appropriate Photo Electric Cells, Safety Bump Strip, Induction Loops and other safety devices to protect both equipment and personnel. Elsema Pty Ltd recommends a Photoelectric Beam to be installed and operational when any of the Auto Close options are used.
- Page 3 Wiring Requirements Single phase 240v 10A non-earth leakage protected power supply to where operator is mounted. *This is required because inverter VSD drive units inherently allow an earth leakage current to flow. This current is minimal but a non RCD protected circuit must be installed and the method of installation done so in accordance AS/NZS 3000:2018 to comply.
- Page 4 Plan View Layout / Conduit Position...
- Page 5 4. Ensure stops are installed on the gate for the fully closed and fully open positions. Connect Photo Electric Beams, Safety Bump Strip and all other safety devices as required. Limit Switch Adjustment Elsema’s Industrial motor kits are equipped with dual limit sensors. The 1 limit slows the gate and the 2 limit stops the gate.
- Page 6 Once the limit switches are adjusted turn the power on to the MCiS control card and follow on screen instructions to profile the gate. The MCiS control card has been specially configured to be used with iS motor kit. For replacements please contact Elsema PTY.
- Page 7 Manual Release Instructions Place key in door lock, turn clockwise till released and pull door open Turn knob anticlockwise approx. ½ a turn to release Gate can now be opened by hand. To re-engage the clutch, move the gate by hand into approx.
- Page 8 Maintenance Details WARNING! Failure to maintain equipment may result in injury or death and/or damage to property and equipment. If the product is not used and maintained in accordance with instructions or recommendations listed in this User Manual, the warranty is negated. Recommended maintenance to be performed on the operator and gate are as follows:- Operator performs over 150 cycles a day every 2 month...
Need help?
Do you have a question about the iS3000 and is the answer not in the manual?
Questions and answers