Advertisement
The new license keys that you require are automatically generated and sent to the
email address on file. If you fail to receive the email with the license keys within 30
days, you should contact technical support.
2. Install each license key:
key...
3. Remove the old licenses, if desired:
a. Check for unused licenses:
b. If the list looks correct, remove the unused licenses:
== Step 2: Verify LIFs and registering the serial number
Before returning the replacement node to service, you should verify that the LIFs are on their home ports,
and register the serial number of the replacement node if AutoSupport is enabled, and reset automatic
giveback.
Steps
1. Verify that the logical interfaces are reporting to their home server and ports:
show -is-home false
If any LIFs are listed as false, revert them to their home ports:
-vserver * -lif *
2. Register the system serial number with NetApp Support.
◦ If AutoSupport is enabled, send an AutoSupport message to register the serial number.
◦ If AutoSupport is not enabled, call
3. If an AutoSupport maintenance window was triggered, end it by using the
autosupport invoke -node * -type all -message MAINT=END
4. If automatic giveback was disabled, reenable it:
-auto-giveback true
== Step 3: Return the failed part to NetApp
Return the failed part to NetApp, as described in the RMA instructions shipped with the kit. See the
Return & Replacements
= Replace a DIMM - ASA A250 :icons: font :relative_path: ./asa250/ :imagesdir: /tmp/d20230728-13098-
1ncp8ai/source/./asa250/../media/
You must replace a DIMM in the controller module when your system registers an
increasing number of correctable error correction codes (ECC); failure to do so
causes a system panic.
About this task
All other components in the system must be functioning properly; if not, you must contact technical
support.
You must replace the failed component with a replacement FRU component you received from your
provider.
system license add -license-code license-key, license-
license clean-up -unused -simulate
NetApp Support
page for further information.
license clean-up -unused
network interface revert
to register the serial number.
storage failover modify -node local
network interface
system node
command.
Part
59
Advertisement
