SATO M8485Se Programming Reference Manual page 34

COMMAND QUICK REFERENCE
INSTRUCTION
PCaa,bbPCF,a,........z
PD
%a
PG
PHa
PIaaa,bbbbb,cc...c
PMa
E/Pro Programming Reference
Unit 3: Code Quick Reference
Flash ROM Setup. Sets the default printer configuration in Flash ROM.
a = Item number setting (F = setting of all items)
b-z = Sets content
Appendix Reference Table XXXX for CT400/410 printer
Appendix Reference Table XXXX for all other printers
Small Label Size Specification. Specifies parameters relative to small label size. Only
applicable to the M10e printer.
= Vertical dimension (480 to 3600 dots)
a
= Horizontal dimension (480 to 1600 dots)
b
c = Label size (00 to 99 dots)
d = Multiple cut labels (01 to 99)
Rotate, Fixed Base Reference Point.
a = 0: Sets print to normal direction
1: Sets print to 90 degrees counter-clockwise
2: Sets print to 180 degrees rotated (upside down)
3: Sets print to 270 degrees counter-clockwise (90x CW)
EEPROM Setup. Sets the default printer configuration in EEPROM.
= Sets content
a-z
Appendix Reference Table 43 for CT400/410 printer
Appendix Reference Table 42 for XL408/410e printers
Appendix Reference Table 41 for M10e printer
Appendix Reference Table 40 for all other printers
Print Method, Thermal/Thermal Transfer. Selects the thermal printing method.
a = 0: Thermal transfer printing
1: Direct thermal printing
PCX File, Store. Stores a PCX graphic file.
aaa = Storage number (001 to 999)
bbbbb = Number of bytes in the file to be stored
cc...c =
Print Mode Selection. Selects desired backfeed operation.
a = 0: No backfeed, continuous operation
1: Tear-Off
2: Cut, backfeed after print
3: Cut, backfeed before print
4: Cut, no backfeed
7: Dispense, backfeed after print
8: Dispense, backfeed before print
DESCRIPTION
3-13
PN: 9001096B