Application Of Input Power; Disconnection Of Input Power - Labomed eVO 350 User Manual

Slit lamp
Table of Contents

Advertisement

SETUP (continued)
UNPACKING AND INSTALLATION (continued)
15. Install the Microscope Assembly onto the top of
the Arm by sliding it into position, making sure
it is up against the stop. Then, tighten the Lock
Knob located on the right side of the Microscope
Assembly. Refer to Figure-9.
Note: Do not adjust the microscope stop knob behind
the base of the microscope, or the vertex distance
will cause misalignment of focus and require re-calibra-
tion of the slit lamp assembly.
16. Remove the accessories and store them in an
appropriate place so that when they are needed
they will be available. Refer to Figure-10.

APPLICATION OF INPUT POWER

WARNING: CARE MUST BE TAKEN TO ARRANGE THE
CABLES FOR THE ACCESSORIES SUCH THAT THEY
DO NOT PRESENT A TRIPPING HAZARD TO THE
EXAMINER OR A DANGER TO THE PATIENT.
WARNING: POSITION THIS INSTRUMENT SO THAT IT
IS NOT DIFFICULT TO OPERATE THE DISCONNECTION
DEVICE (PLUG).
1. After the unit is in its secure location, apply the
correct input voltage to the instrument using the
Power Cord from the Accessory Tray.
Note: The power inlet is located on the backside of
the Power Supply Assembly.
2. Press down on the "|"located on the ON/OFF
Switch. Refer to Figure-11.
Note: The ON/OFF Switch will illuminate green when
there is power to the unit. When the ON/OFF Switch
is set to off, the green light will turn off.

DISCONNECTION OF INPUT POWER

1. At any time, the power switch can be set to OFF.
The unit does not have a power down sequence.
To terminate operation of this instrument, press the
ON / OFF switch to the OFF position (O).
2. If this instrument is intended to be OFF for an
extended period of time, it can be disconnected
from power by detaching the power cord from the
receptacle.
8126300-795
Power
Cord
Wrenches
Figure-11 Power Supply Assembly
eVO 350
Slide
Microscope
Assembly
Turn Counterclockwise
Lock Knob
Figure -9 Install Microscope
Focusing
Rod
Dust
Cover
Guide Rails
Replacement
Figure -10 Accessories
ON/OFF Switch
Issue 1.2
Printed on June,2020
eVO 350
Chin Paper
Bulb
11

Advertisement

Table of Contents
loading

Table of Contents