Important Reminders - Martec VAMPIRE Series Instruction Book

INSTALLING RECEIVER REMOTE CONTROL

IMPORTANT REMINDERS

1. Please note: Receiver must be correctly installed in the mounting bracket on fan.
2. When the transmitter cannot control the receiver, please check the battery has sufficient charge in
the transmitter.
3. When the transmitter cannot control the receiver, please check if there is any existence of similar
remote controlled products nearby, causing interference with each other.
4. Low power of battery will affect the sensitivity of the transmitter and the signal reception accordingly,
the battery must be replaced if power is getting low.
5. Please take the battery out from the transmitter when leaving unused for a long time, to avoid
battery leaks.
6. Isolation Switch "Must be connected in the line."
7. When power is cut to the unit (via a blackout or otherwise) when power is restored the light will
come on.
8. The dimming switch on the light models is operated by turning the light ON/OFF button within
1 second.
9. The light will dim in stages from 24W to 9W to 3W approx.
10. Polarity
11 Ensure power is OFF before plugging in receiver
12. Please be careful not to slice wires when attaching top canopy to ceiling.
13. A slight delay may occur when the blades fully expand or retract
IMPORTANT NOTICE
RETRACTABLE CEILING FANS WILL OMIT A NOISE WHEN THE BLADES AND BLADE ARMS ARE IN EXPANDING
AND RETRACTING MODES, THESE NOISES ARE UNAVOIDABLE AND ARE NOT COVERED BY THE
MANUFACTURERS WARRANTY ATTACHED TO THIS PRODUCT.
Before carrying out any cleaning or maintenance, please ensure that the appliance is disconnected.
Please note that the LED light cannot be removed, replaced or is interchangeable with any
other appliance.
02 8778 7500 | sales@martecltd.com.au | www.martecaustralia.com.au
Page 7