Advertisement
Thank you for purchasing your MARTEC RAZOR Series product. Please read all instructions carefully before
assembly and use.
IMPORTANT SAFEGUARDS
READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING OR USING THE PRODUCT. KEEP THE
INSTRUCTIONS HANDY FOR FUTURE REFERENCE.
IMPORTANT:
Always operate the product from a power source of the same Voltage, Frequency and rating
as on the product Identication Plate.
IMPORTANT:
The fan is to be installed so that the blades are more than 2.1 metres above the floor.
Avoid contacting moving parts, keep hands, hair and clothing well away from the product while it is in
operation.
A Luminaire (light fitting) included in the fan packaging may only be fitted to this fan.
"This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety."
"Young children should be supervised at all times to ensure that they do not play with the appliance."
Do not operate any product which has been or appears damaged in any matter or after the product
malfunctions.
CAUTION: To reduce the risk of electric shock, do not install the product where it can be exposed to rain,
moisture or any liquid.
Do not use the product for other than its intended use as described in these instructions. This product
is intended for normal domestic household use only. The use of accessory attachments other than those
recommended by the manufacturer may cause safety hazards.
SAFETY
Installation of fans must follow S.A.A. standards and meet local Authority regulations. A fully qualified and
licensed electrician lawfully MUST carry out installation. Means for disconnection must be incorporated in
the fixed wiring in accordance with wiring rules.
Fan and light MUST be earthed. Bracket MUST be firmly attached to a solid structure i.e. concrete ceiling,
steel structure or timber frame, etc. and MUST be nailed between beams if the timber option is required.
ONLY install the wall controller kit that comes supplied by Martec Pty Ltd within package. DO NOT control
operation of fan and light with any other wall control than what was approved by Martec Pty Ltd and
supplied within this package, as this will void warranty.
WARNING
Only approved Martec Pty Ltd wall controllers should be used for the operation of our fans. The use of
unauthorised controllers will void the warranty. DO NOT mix blades from one fan to another. All blades
must be replaced if damaged.
Page 1
02 8778 7500
|
sales@martecltd.com.au
|
www.martecaustralia.com.au
Advertisement
