How To Assemble - Martec VAMPIRE Series Instruction Book

HOW TO ASSEMBLE

Secure the hanger bracket to ceiling beam or a suitable piece of timber inserted between the ceiling
beams. Place circular shockproof gasket above the hanger bracket. Align the bracket and screw the
hanger bracket to the ceiling tightly. (See Fig.1).
Martec Pty Ltd recommends the bracket to be attached with two long screws as supplied within the
package.
Place fan into hanger bracket and tighten the screws refer to the following steps. After wiring is
completed, attach the canopy to the hanger bracket by pushing upwards and twisting anticlockwise.
Locate screws in keyholes and tighten (See Fig.2).
HOW TO INSTALL FAN
1. The horizontal pin passes through the boom and is then installed in the slot of the hanger (See Fig.3)
2. Screw the lock block with the supplied heavy duty hex nut screws to prevent the derrick from becoming
loose (See Fig.4).
Fig.3 Fig.4
Page 4
02 8778 7500 | sales@martecltd.com.au | www.martecaustralia.com.au