Table of Contents
Advertisement
3.15
Antenna
Genio 700 EVK board has three SMA connector. Users can connect them via SMA antenna. At First, three IPEX RF cables
must be connected to WiFi module and IPEX Connector (CON4000, CON4001 and CON4002). These antennas are designed
for AzueWave M.2 (MT7921L) WiFi module.
Location
J4002
J4003
J4004
3.16
How to Power Up the Genio 700 EVK
Power on Genio 700 EVK board by following steps.
1.
You must install the Camera DTB on the Genio 700 EVK board.
(If the camera app is not on the desktop , please refer to Appendix for fixing it )
2.
Connect UART0 (CN3200) to the computer via an USB cable. (If you want to see the logs.)
3.
Power on the system by long pressing Power Key for 4 seconds or Plug a Jumper at J3001 and Auto power on by plug
in of AC adaptor.
4.
You will see the boot-up picture on LCD display and some trace logs come out from UART0.
3.17
How to Reflash the Codes of Genio 700 EVK
Following steps can reflash the system codes of Genio 700 EVK board.
1.
Connect ADB port to PC Via Micro USB (CON480)
2.
Execute MediaTek Flash Tool
3.
Select the proper Download-XML file.
4.
Select the download mode ("Firmware Upgrade" is preferred.)
5.
Start download by pressing the button of "Download".
6.
Plug in the DC power cord , the downloader will start.
Note:
If the downloader does not start.
Press Download button and plug in the DC power cord will execute a force download.
MediaTek Proprietary and Confidential. © 2022 MediaTek Inc. All rights reserved. Unauthorized reproduction or disclosure of this document, in whole or in part, is strictly prohibited.
Band
2.4GHz / 5GHz
2.4GHz / 5GHz
2.4GHz / 5GHz
Table 3-8. SMA Antennas
Genio 700 EVK Hardware User Guide
Note
WiFi / BT
WiFi / BT
WiFi / BT
Genio 700 EVK
21
Advertisement
Table of Contents
