Table of Contents
Advertisement
Operation
Main Level
Programming Levels
DMX Loss
Indicator
Setup
Flash if
DMX
Follow
Spot
Ver:
Running Mode:
Sys Info
DMX Address:
Temperature:
DFI:
DMX Configuration
The Intimidator Spot 160 ILS works with a DMX controller. Information about DMX is in the Chauvet DMX
Primer available from the Chauvet website:
http://www.chauvetlighting.com/downloads/DMX_Primer_rev05_WO.pdf.
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels the selected DMX
mode uses. If the starting address is set too high, access to some of the product's channels could be
restricted. The Intimidator Spot 160 ILS uses up to 11 DMX channels, which defines the highest
configurable address to 502.
For information about the DMX protocol, download the DMX Primer from www.chauvetdj.com.
To select the starting address, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Address.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select the starting address, from 001–512.
5. Press <ENTER>.
DMX Personalities
The Intimidator Spot 160 ILS has two DMX personalities: an 11-channel personality and a 5-channel
personality.
To select a DMX personality, follow the instructions below.
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Run Mode.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select DMX.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select the DMX personality, 05CH or 11CH.
7. Press <ENTER>.
Intimidator Spot 160 ILS User Manual Rev. 2
Hold
Black
Auto
Sound
ON
OFF
ON
OFF
ON
OFF
Reset
Factory Set
V_
_ _ _ _ _ _ _ Displays the current running mode
_ _ _
_ _ °C
_ _ _ _ _ _ _ Displays connected D-Fi (if available)
Description
Holds the last setting when signal is lost
Blacks out the product when signal is lost
Sets the unit to Auto mode when signal is lost
Sets the unit to Sound mode when signal is lost
Enables/disables LED indicator
LED indicator flashes when fixture is connected to DMX
LED indicator flashes when fixture is disconnected from DMX
Enables fixture to be controlled via ILS command
Disables Follow Spot mode
Resets the product
Loads factory defaults
Displays the firmware version
Displays the current DMX address
Displays the product temperature in °C
7
Advertisement
Table of Contents
