Table of Contents
Advertisement
3. Setup
AC Power
The Intimidator Spot 160 ILS has an auto-ranging power supply, and it can work with an input voltage
range of 100 to 240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product's back panel, or refer to the product's specifications chart.
The listed current rating indicates the product's average current draw under normal conditions.
•
Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use,
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0–100% switch.
Fuse Replacement
1.
Disconnect the product from power.
2.
Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3.
Remove the blown fuse.
4.
Replace with a fuse of the same type and rating (F 2 A, 250 V).
5.
Screw the fuse holder cap back in place and reconnect power.
Disconnect the product from the power outlet before replacing the fuse.
Power Linking
The product provides power linking via the outlet located in the back of the product. See the diagram below
for further explanation.
Power-Linking Diagram
Additional products
It is possible power link up to 7 Intimidator Spot 160 ILS products on 120 VAC or up to 12
products on 230 VAC.
4
Intimidator Spot 160 ILS User Manual Rev. 2
Setup
Power
source
Advertisement
Table of Contents
