Advertisement
5. FEATURES GUIDE
Run and stop the machine
Reverse the rollers to undo jams
and correct misfed documents
Reduce roller speed
(1~10 speed settings)
Increase roller speed
(1~10 speed settings)
25~38mic
Laminate 25~38mic (1~1.5mil) film
(1~1.5mil)
50~100mic
Laminate 50~100mic (2~4mil) film
(2~4mil)
125mic
Laminate 125mic (5mil) film
(5mil)
6
6. OPERATION INSTRUCTIONS
Power Switch (1)
- Located on the rear of
the machine. "I" (on) "0" (off). (Fig. 1)
Cross Cutter (2) - Used to cut off the
laminated web. (Fig. 1)
Feed Guide (3) -The feed guide permits
alignment of the item(s) to be laminated. To
position the adjustable guide, loosen the knob,
slide it to the desired position and tighten the
knob to secure the feed guide in place. (Fig.2)
Safety Shield (4) - It prevents entanglement
NOTE: If the safety shield is opened, the power
to the motor will turn off.
Film Shaft and Locking
Core Adapter (5) -
The film shaft holds the film supply on the
machine. The locking core holds and locks the
film on the shaft to prevent shifting. (Fig.3)
Film Tension Adjustment (6) - Allows the
operator to increase or decrease film web
tension. To increase the tension turn the knob
clockwise and to decrease tension turn the
knob counterclockwise. (Fig. 4)
RSL-380
Figure 1
Figure 2
Figure 3
Figure 4
7
Advertisement
