Lectrosonics LT/E01 Instruction Manual page 25

Step 3:
Refer to Step 1 to return to Firmware web page. Down-
load Firmware Update and save to a local file on your
PC for easy locating when updating.
Step 4:
Open Lectrosonics USB Firmware Updater.
Step 5:
Put the transmitter in UPDATE mode
by simultaneously holding down the
UP and DOWN arrow buttons on the
UPDATE
transmitter control panel while
powering it up.
Step 6:
Using a microUSB cable, connect the transmitter to
your PC.
Rio Rancho, NM
Digital Hybrid Wireless Belt-Pack Transmitter
Step 7:
In Lectrosonics USB Firmware Updater, choose the
detected device, browse to local Firmware File and click
Start.
NOTE: It may take up to a minute or so for the
Updater to recognize the transmitter.
WARNING: Do not disrupt the microUSB cable during
updating.
The Updater alerts with progress and completion.
Step 8:
Once the Updater has completed,
LT/E01
turn off the transmitter, then turn it
back on to verify that the firmware
V2.04
version on the transmitter LCD
Band B1
matches the firmware version shown
Hybrid on the web site. The firmware is the
second LCD display during boot up
sequence.
Step 9:
Close Updater and disconnect microUSB cable.
25