Setup; Ac Power; Mounting; Orientation - Chauvet DJ ILS COMMAND User Manual

Setup

3. Setup

AC Power

The ILS Command comes with an external auto-ranging power supply which can work with an input
voltage range of 100 to 240 VAC, 50/60 Hz and outputs 5 VDC.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the current
value listed on the label affixed to the product's back panel, or refer to the product's specifications chart.
The listed current rating indicates the product's average current draw under normal conditions.
• Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or
fire.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.

Mounting

Before mounting the product, read and follow the safety recommendations indicated in the

Orientation

The ILS Command has 4 rubber feet for placing on a flat surface. Make sure adequate ventilation is
provided around the product.
ILS Command User Manual Rev. 1
Safety Notes.
4