Black Box AlertWerks AW3000 User Manual page 41

CHAPTER 11: TIPS AND TRICKS
TABLE 11-1. TYPES OF DASHBOXES WHEN SELECTING A DATAPOINT
TYPE
Graph
Tacho
Traffic Sign
Value
Map
TYPE
Clock
Overview
Image
3D
Camera
Map
11.1.8 4G/LTE CONNECTIVITY
AW3000 is prepared to accept 4G/LTE USB sticks. Make 3372 from Huawei is compatible. This allows you to connect
AW3000 units to the internet by plugging in the 4G USB stick and entering the PIN for the new upcoming interface.
From the Settings menu, you can then use the Dynamic DNS functionality to obtain units. If you are using the
redundancy feature mentioned earlier with 4G, consider latencies and other network issues.
SMS sending or actions with outgoing voice calls is not allowed when using 4G/LTE USB sticks.
11.1.9 AMOUNT OF SENSORS, DATAPOINTS, AND ACTIONS OR THE BEENLATE FACTOR
The amount of sensors, datapoints, and actions is not limited by nature of programming, since you define the limit. If
you configure virtual sensors with their lowest intervals, AW3000 will eventually no longer allow new creation of virtual
sensors. In the background the "BeenLate" factor is calculated which gives the unit an impression if all jobs are done on
time. If that is not the case, the "BeenLate" factor rises.
The unit considers timing and will not allow all events happen at the same time. Below is a small table of what is
possible:
Intervals below 1 minute:
Intervals 1-10 minutes:
Intervals 10-30 minutes:
Intervals 30+ minutes:
We can only provide approximate values here because latency and Time-on-Air differs from physical to physical sensor
and from virtual to virtual sensor.
NOTE: Not every IP device answers an SNMP get instantly.
DESCRIPTION
This gives you a graph. You can also define the time scope.
This gives you a tacho. If you configured Thresholds, these are accordingly used. Without thresholds
the tacho uses min/max value of the time scope defined.
This gives you a traffic sign. It is either red, yellow, or green. This dashbox needs thresholds to be set.
This dashbox displays the current value. The system allows the option of having the background
color change on values if thresholds are defined.
This dashbox shows a map. The value needed is COMBINED GPS Coordinates. This means you need
to first create a virtual sensor to do COMBINE with latitude and longitude of a GPS Tracker sensor.
TABLE 11-2. GENERAL DASHBOXES
DESCRIPTION
This dashbox shows either a digital or analog clock.
This dashbox is only available with sensor grouping enabled. (See Settings.) A list with values of all
sensors in a certain group appears.
This dashbox shows an image (See chapter 9).
This dashbox shows an 3D image and allows you to move it.
This dashbox shows pictures from IP Cameras.
This dashbox shows a map just like the dashboard feature EARTH, but as one dashbox. This feature
needs Sensor Grouping enabled and Group names to be defined in the dashbox's settings.
maximum physical/virtual sensors and actions: 10
maximum physical/virtual sensors and actions: 25+
maximum physical/virtual sensors and actions: 50+
maximum physical/virtual sensors and actions: 100+
1.877.877.2269 BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
41