YASKAWA CIMR-AC4A WAA Series Quick Start Manual page 24

Hide thumbs Also See for CIMR-AC4A WAA Series:

5 Start Up



Test Run

Perform the following steps to start up the machine after all parameter settings have been done.

Run the motor without load and check if all input, outputs and the sequence work as desired.

Connect the load to the motor.

Run the motor with load and make sure that there is no vibrations, hunting or motor stalling occurs.

After taking the steps listed above, the drive should be ready to run the application and perform the basic functions. For

special setups like PID control etc. refer to the Technical Manual.

EN 24

YASKAWA Europe TOEP_C710606_97A - AC Drive A1000 IP54READY - Quick Start Guide

Table of Contents