Edirol UA-20 Owner's Manual page 68

Appendices
■Windows 98 users
The USB composite device driver is installed
first, then the USB audio device driver is
installed. Use the following procedure to
install the drivers.
1. With the UA-20 disconnected, start up
Windows.
Disconnect all USB cables except for a USB
keyboard and USB mouse (if used).
2. Exit all currently running software
(applications).
If you are using a virus checker or similar
software, be sure to exit it as well.
3. Place the UA-20's ADVANCED (mode select)
switch in the OFF position.
4. Use the USB cable to connect the UA-20 to
your computer.
This unit is equipped with a protection circuit. A
brief interval (a few seconds) after connecting a USB
connector is required before the unit will operate
normally.
5. USB composite device will be detected
automatically, and the "Add New Hardware
Wizard" dialog box will appear. Click [Next].
6. When "What do you want Windows to do?"
appears, select "Search for the best driver
for your device (Recommended)", and click
[Next].
fig.05-27e_30
7. A dialog box like the one shown will appear.
Check CD-ROM drive, and click [Next].
If the display indicates "Can't find an updated
driver for this device", check "Updated driver",
and click [Next].
fig.05-28e_30
68
8. A dialog box like the one shown will appear.
Click [Next].
Depending on your system, the Driver location
may differ from the illustration, but this is not a
problem.
9. File (driver) copying will begin.
If the Windows CD-ROM is not inserted
in the CD-ROM drive, a "Insert Disk"
dialog box may appear. In this case, insert
the Windows CD-ROM into the CD-ROM
drive and click [OK].
10.When installation of the USB Composite
Device driver is completed, a dialog box like
the one shown here will appear.
Click [Finish].
fig.05-27e_30
11.Next, the USB audio device will be detected
automatically, and the "Add New Hardware
Wizard" dialog box will appear.
Click [Next], and proceed with the installation
in the same way as in steps 8-11 .
12.When installation of the USB audio device
driver is complete, a dialog box like the one
shown here will appear.
Click [Finish].
fig.05-27e_30
Installation of the USB composite device
driver and USB audio device driver has been
completed.
Restart Windows.
Next, you will need to make the driver
settings.(➝ Driver settings (p. 26))