Edirol UA-20 Owner's Manual page 15

11
Use the USB cable to connect the UA-20 to your computer.
Near the task bar, your computer will indicate "Found New
Hardware". Please wait.
12
The Found New Hardware Wizard will appear.
Select "Install from a list or specific location (Advanced)",
and click [Next].
13
The screen will indicate "Please choose your search and
installation options".
Select "Don't search. I will choose the driver to install",
and click [Next].
14
Make sure that the "Model" field indicates "EDIROL UA-
20", and click [Next]. Driver installation will begin.
If the "What action do you want Windows to take?" (Step 4) setting was not
set to "Ignore", a "Hardware Installation" dialog box will appear.
A dialog box with a "!" symbol will appear.
1.
Click [Continue Anyway].
2.
Continue the installation.
A dialog box with a "x" symbol will appear.
1.
Click [OK].
2.
When the "Found New Hardware Wizard" appears, click [Finish].
3.
Return to step 1 (p. 13) and re-install the driver from the beginning of the
procedure.
15
The Insert Disk dialog box will appear.
Click [OK].
Driver installation and settings (Windows)
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting the USB cable is
required before the unit will
operate normally.
If the Found New Hardware
Wizard asks you whether you
want to connect to Windows
Update, choose "No" and then
click [Next].
The Insert Disk dialog may
not appear. In that case,
proceed to the next step.
15