Edirol UA-20 Owner's Manual page 41

FreeMIDI settings
1
Set the UA-20 ADVANCE (mode select) switch to the ON
position.
2
Use the USB cable to connect the UA-20 to your Macintosh.
3
From the CD-ROM, drag the Driver E (Mac OS 9) -
FreeMIDI Setting folder into the FreeMIDI Applications
folder on the hard disk of your Macintosh to copy it there.
4
Open the FreeMIDI Applications folder from the location
into which you installed FreeMIDI, and double-click the
FreeMIDI Setup icon to start it up.
5
The first time you start up, use the following procedure.
1.
A dialog box saying "Welcome to FreeMIDI!" will
appear.
Click [Continue].
2.
The FreeMIDI Preferences dialog box will appear.
Click [Cancel].
3.
The About Quick Setup dialog box will appear.
Click [Cancel].
6
From the File menu, choose Open.
7
Select UA-20 from the FreeMIDI Setting folder you copied in
step 3, and click [Open].
8
Verify that MIDI transmission and reception occur correctly.
From the MIDI menu, choose Check Connections.
Driver installation and settings (Macintosh)
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting the USB cable is
required before the unit will
operate normally.
When "OMS is installed on
this computer..." appears,
click [FreeMIDI].
If you are unable to select
Open, make settings as
follows.
1. From the File menu, choose
FreeMIDI Preference.
2. Uncheck "Use OMS when
available."
3. Close FreeMIDI.
4. Return to step 4 and
continue the procedure.
41