Edirol UA-20 Owner's Manual page 67

■Windows Me users
1.
With the UA-20 disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB mouse (if used).
2.
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit it as well.
3.
Place the UA-20's ADVANCED (mode select) switch in the OFF position.
4.
Use the USB cable to connect the UA-20 to your computer.
942*
This unit is equipped with a protection circuit. A brief interval (a few seconds) after
connecting a USB connector is required before the unit will operate normally.
5.
Windows will detect the UA-20, and the "Add New Hardware Wizard" dialog box will
appear.
Make sure that Automatic search for a better driver (Recommended) is selected, and
click [Next].
6.
Driver detection will begin.
* Depending on your system, a certain amount of time may be required for the device to be detected
after the driver has been installed.
7.
When the driver has been found, driver installation will begin.
8.
Once the driver has been installed, a dialog box will inform you of this.
Click [Finish].
9.
Restart Windows.
10. Next, you will need to make the driver settings.
(➝"Driver settings" (p. 26))
Appendices
67