About The Effect Controllers - Roland Audio Canvas UA-100 User Manual

GAME mode
Select this mode when the UA-100 is connected to your computer and you wish to
apply the UA-100's Game effect to the output of the computer's audio device. In this
mode, the effect will be applied to the signal that is input to the Roland UA-100 Wave
1 audio device. You can use the UA-100 Controller to change the effect parameters that
are assigned to be controlled by the front panel Effect Controller knobs 1–4. You can
also use the UA-100 Controller to specify the default settings of the effect parameters
that will be used when GAME mode is selected.
BYPASS mode
Select this mode when you want the input signal from the front panel Mic 1/Guitar
Input Jack and the Mic 2 Input Jack to be output without change.

About the Effect Controllers

You can control the effects of the UA-100. The effect parameters assigned to each knob
will differ depending on the effect type.
With the factory settings, they have the following assignments.
fig.01-01
(This is also printed on the top panel of the UA-100.)
When you switch the Effect Type Selector, the value of each effect parameter will be
reset to the default value regardless of the position of the effect controller knobs. You
can move the effect controller knobs to adjust the parameters.
You can use the UA-100 Controller to change the parameters that are assigned to each
effect controller and the default values of the parameters. For details refer to "About
the UA-100 Controller" (p. 14) and the UA-100 Controller Help.
If the Effect Type Selector is in the PC or BYPASS position, the effect controller settings
will not function. In order to enable the effect controller settings, you must set the Effect
Type Selector to a position other than PC or BYPASS.
Front Panel
9