Table of Contents
Advertisement
Programming a Daily Schedule
Continued
Select Morning Cool Setpoint - Press the WARMER or COOLER
buttons to adjust the cool setpoint desired. This step will appear
if Cool or Auto Mode was selected in the step where the Morning
mode is specified. Press MODE to advance to the next step.
Select Morning Heat Setpoint - Press the WARMER or COOLER
buttons to adjust the heat setpoint desired. This step will appear if
Heat or Auto Mode was selected in the step where the Morning
mode is specified. Press MODE to advance to the next step.
Repeat previous steps for Day, Evening, and Night programming.
Copy Program - Press the UP button to Copy the current day's
program to the next day. Press MODE again to continue copying the
following day.
Press and hold the MODE and WARMER buttons to exit Time Period
Programming at any time.
Press the MODE button to cycle through OFF, then the available
modes (Setup Step 14) until Program ON is displayed. Note that this
sequence may be restricted due to settings on the Skyport website.
The thermostat can be configured to be non-programmable which
will prevent Program ON from appearing in the MODE sequence.
The thermostat can also be configured to force the program to
always be running so the MODE button will have no effect.
33
Advertisement
Table of Contents
