Overclock Running - JETWAY For Socket 370 User Manual

may cause the processor and motherboard overheat and damage,
you may install an auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF
socket and open it by first pulling the level sideways away from the socket then
upward to a 90-degree angle. Insert the CPU with the correct orientation as shown
below. The notched corner should point toward the end of the level. Because the CPU
has a corner pin for two of the four corners, the CPU will only fit in the orientation as
shown.
When you put the CPU into the ZIF socket. No force require to insert of the CPU,
then press the level to Locate position sightly without any extra force.
2-3-4 Over clock Running
WARNING! This section is for experienced motherboard installer only. Over
clocking can result in system unstability or even shortening life of
the processor.
After setting the Jumper JP2 you can choose overclock running by BIOS CMOS
SETUP UTILITY. When you entered CMOS SETUP UTILITY, choose "Frequency/
Voltage control" you will see the screen as below then.
1. You can choose the situation you want to try.
CPU/SDRAM (MHz)
66/66
66/100
100/100
100/133
133/100
1-2 3-4 5-6
OFF OFF OFF
OFF OFF OFF
ON OFF OFF
ON OFF ON
ON ON OFF
12
7-8
ON
OFF
OFF
OFF
OFF