Overclock Running - JETWAY 815EDA1A User Manual

When you put the CPU into the ZIF socket. No forces require to insert of the CPU, then press
the level to locate position slightly without any extra force.
2-3-4 Over clock Running
WARNING! This section is for experienced motherboard installer only. Over clocking
can result in system instability or even shortening life of the processor.
After setting the Jumper
CMOS SETUP UTILITY.
"Miscellaneous Control" you will see the screen as below then.
You can choose the situation you want to try.
CPU/SDRAM (MHz)
AUTO
66/100 (Default)
100/100
133/100
133/133
CMOS Setup Utility – Copyright(C) 1984-2002 Award Software
CyrixIII Clock Ratio
Auto Detect DIMM/PCI Clk
Spread Spectrum
** Current Host Clock is 66Mhz **
CPU Host/SDRAM/PCI Clock
CPU Clock Ratio
Flash Part Write Protect
↑↓→← Move Enter:Select
F5:Previous Values
By press PageDown/PageUp key you can change the CPU Host/SDRAM/PCI Clock
When jumper setting CPU Host Clock 66MHz you can choose 66/100/33∼99/149/49MHz
When jumper setting CPU Host Clock 100MHz you can choose 100/100/33∼132/132/44MHz
When jumper setting CPU Host Clock 133MHz you can choose 133/100/33∼200/151/50MHz
When jumper setting CPU Host Clock 133MHz you can choose 133/133/33∼200/200/50MHz

Pentium III
Colden Arrow
CPU ZIF Socket 370
JS1, JS2, JS3, JS4
When you entered CMOS SETUP UTILITY, choose
JS1 JS2
ON ON
OFF OFF
OFF OFF
OFF OFF
OFF OFF
Miscellaneous Control
Default
Enabled
Disabled
66/100/33Mhz
X 3
Enabled
+/-/PU/PD:Value F10:Save ESC:Exit
F6:Optimized Defaults
11

Intel
you can choose over clock running by BIOS
JS3 JS4
1-2
2-3
1-2
1-2
2-3
Menu Level >
F7:Standard Defaults
1-2
2-3
2-3
1-2
1-2
Item Help
F1:General Help