Setting Cpu Bus Clock & Memory Clock Jumper; Install Cpu - JETWAY For Socket 370 User Manual

Celeron FC–PGA
On the surface of the CPU as shown on the right picture, under the word of "Celeron"
the code is:
566/128/66/1.5V
566 :
CPU internal frequency, where here is 566MHz
128 :
the size of L2 cache, where here is 128K
66 :
front side bus frequency, where here is 66MHz
1.5V :
the voltage for the CPU
2-3-2 Setting CPU Bus Clock & Memory Clock Jumper
Setting the front side bus frequency and SDRAM frequency
The motherboard uses jumper JP2 for the front side bus frequency and SDRAM
frequency setting as shown from the table below:
CPU/SDRAM (MHz)
66/66
66/100
100/100
100/133
133/100
133/133
Example: Using a Pentium  III 866 CPU with front side bus frequency of
133MHz and PC-133 SDRAM module, the setting of JP2 are 1-2 closed,
3-4 closed, 5-6 closed for CPU BUS CLOCK to be 133MHz and SDRAM
CLOCK to be 133MHz.
For experience user looking for over clocking, Please refer to sec 2-3-4

2-3-3 Install CPU

This motherboard Provides a ZIF socket 370.
motherboard should have a cooling FAN attached to prevent overheating. If this is not
the case, then purchase a correct cooling FAN before you turn on your system.
WARNING! Be sure that there is sufficient air circulation across the processor's
heatsink and CPU cooling FAN is working correctly, otherwise it
1-2 3-4 5-6
OFF OFF OFF
OFF OFF OFF
ON OFF OFF
ON OFF ON
ON ON OFF
ON ON ON
11
7-8
ON
OFF
OFF
OFF
OFF
OFF
The CPU that comes with the