Table of Contents
Advertisement
2-3-2 Setting CPU Bus Clock & Memory Clock Jumper
Setting the front side bus frequency and SDRAM frequency
The motherboard uses jumper less function for the front side bus frequency and SDRAM
frequency users don't need setting any jumper when plug the CPU in motherboard
For experience user looking for over clocking possibility, please refer to sec 2-3-4.
2-3-3 Install CPU
This motherboard provides a ZIF socket 370. The CPU that comes with the motherboard
should have a cooling FAN attached to prevent overheating. If this is not the case, then
purchase a correct cooling FAN before you turn on your system.
Be sure that there is sufficient air circulation across the processor's
WARNING!
heatsink and CPU cooling FAN is working correctly, otherwise it may
cause the processor and motherboard overheat and damage, you may install
an auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF socket and
open it by first pulling the level sideways away from the socket then upward to a 90-degree
angle. Insert the CPU with the correct orientation as shown below. The notched corner
should point toward the end of the level. Because the CPU has a corner pin for two of the
four corners, the CPU will only fit in the orientation as shown.
When you put the CPU into the ZIF socket. No forces require to insert of the CPU, then press
the level to locate position slightly without any extra force.
2-3-4 Over clock Running
WARNING!
This section is for experienced motherboard installer only. Over clocking
can result in system instability or even shortening life of the processor.
Users can choose over clock running by BIOS CMOS SETUP UTILITY. When you entered
CMOS SETUP UTILITY, choose "Miscellaneous Control" you will see the screen as below
then.
Pentium
III
Colden Arrow
CPU ZIF Socket 370
9
Intel
Advertisement
Table of Contents
