Montigo Divine H36PV Installation & Maintenance Manual page 17

Step 8: Install the Power Vent Power / communication harness. Hold
the Power Vent in close proximity of the assembled Rough-in Kit,
and plug in the Power Vent communication / Power Cord. (Note the
direction and orientation of the pins inside the Power Vent connector,
snap together). (Figure 4.e).
Figure 4.f Installation of Power Vent communication harness
Step 9: Install the Power Vent. Place the Power Vent into the Rough-in
frame, aligning the Power Vent into final position. Ensure the Harness
is placed down in the Rough-in box when placing the Power Vent.
(Secure the Power Vent in Place with the supplied hardware).
Figure 4.g Completed Installation of Power Vent
XG0649 - 080921
Installation Installation
TOP of Power
Vent,
(Note Quantity of
louvers).
Note
louver
direction
Tightened hardware,
4-pcs.
H36PVN Power Vent Indoor Gas Fireplace
Wiring Installation
Connect the wiring to the external power vent termination as outlined
in the previous section, and connect the wiring to the fireplace as
outlined in the schematic below. Ensure that the proper clearances
are maintained for the wiring and conduit.
• When installing the wiring it must never run above the vent run
and it must be at least 1" clear of all venting.
1" min.
Cable
WARNING
Montigo will not be held responsible for any water damage that may
occur from not installing the equipment as specified by this document.
Vent
Page 17