Table of Contents
Advertisement
20"
Max
Step 8:
Push the molex
connector of the control cable
through the hole in the control
cable cover. Make sure the
molex clicks in place so it does
not fall out. Screw control cable
cover back in place.
Figure 3.i
Step 9:
Drop the rough in
box over top of and inside the
Chase.
Figure 3.j
Step 10: Take the last section
of pipe and install the vent clamp
around the pipe. The bottom of
the band should be 6 3/8" from
the top of the pipe. Tighten the
clamp using the supplied nut
and screw.
Figure 3.k
Step 11: Drop pipe down into
the frame box. The pipe should
be flush with the top of the frame
box. Secure pipe connection
below.
Figure 3.l
Step 12: Connect power cable
of termination to the molex of
the control cable.
Figure 3.m
XG0649 - 080921
Min
Installation
Installation
5
10
"
8
270
Min
Step #2
Install the vent pipe female end up 2"
- 3" from the top of the chase box.
Install the electrical harness (EPVH-
10-100) that will communicate with
the Power Vent module.
6⅜
24
Min
Step #4
Place termination head over chase
and fasten with 4 screws on the
vertical sides of the base plate.
Step 13: Place power vent
Silicone or seal the base plate in
over chase and fasten with 4
any location necessary to keep the
screws on the vertical sides of
structure of the building free of
the base plate. Silicone of seal
water or moisture.
the base plate in any location
necessary to keep the structure
of the building free of water or
moisture.
Figure 3.n
Conduit and Wiring Clearances
Connect the power vent harness as outlined. Connect the wiring to the
fireplace as outlined in the schematic showin in Figure 14 Section 3.
Ensure that the proper clearances are maintained for the wiring and
conduit. When installing the wiring, it must never run above the vent
pipe and it must be at lest 1" clear of all venting and other hot surfaces.
Wire
Power Vent Wiring
H36PVN Power Vent Indoor Gas Fireplace
Attachment
locations
1" Clearance
BLUE
RED
AIR SWITCH
screw
Page 13
Advertisement
Table of Contents
