Table of Contents
Advertisement
ADDITIONAL SETTINGS/WEITERE EINSTELLUNGEN
Control unit standby
I/O button's background light glows on the control panel.
Open the settings menu by simultaneously pressing the locations of the buttons –, MENU
and + (see figure 2). Press for 5 seconds.
The buttons do not glow when the control unit is in standby mode.
Setting the remote use
The remote use setting can be changed with the — and + buttons. The options are "OFF"
(remote control disabled), "SAFE" (safety switch).
See section 2.3.3. for further information.
Confirm the selection with the MENU button.
Setting pause time. Enable or disable the pause time feature with buttons + and -. Pause
time must be enabled, if the control unit is remotely started by an automated schedule
(e.g. a weekly timer).
Press the MENU button to access the next setting.
Maximum on-time
The maximum on-time can be changed with the – and + buttons. The range is 1–12 hours
(6 hours*)).
Example: the heater will be on for 6 hours from the start.
(Remaining on-time can be changed, see figure 3a.)
Press the MENU button to access the next setting.
Sensor reading adjustment
The reading can be corrected by +/- 10 units. The adjustment does not affect the meas-
ured temperature value directly, but changes the measuring curve.
Press the MENU button to access the next setting.
Memory for power failures
The memory for power failures can be turned ON or OFF *).
When turned on, the system will start again after a break in electricity.
•
When turned off, the break will shut the system down. I/O button must be pressed to
•
restart.
The safety regulations for memory usage vary from region to region.
•
EN
*) Factory setting
7
Advertisement
Table of Contents
