Battery - BYD e2 Owner's Manual

104 4-2 Battery

Warning
●
The owner of new energy vehicle is liable to and responsible for delivering the used
power battery to the recovery service network. If the used power battery is handed
over to other organizations or individuals for disassembly and dismantling, the
resulted environmental pollution or safety accident shall be borne by the users.

Battery

■
Check the conditions of the power battery once a month. Check the terminals for
corrosion.
■
If there is some corrosion on the terminals, must apply a soda solution onto the surface
of the terminals, where some bubbles will be generated and the soda solution will be
gradually turned into brown. After the bubbles are no longer emitted, wash the
terminals with clean water and wipe them with a cloth. Finally, apply the grease onto
the surfaces of the terminals to prevent corrosion.
■
If the connector is loosened, tighten the nut on the clamp to a certain tightening torque.
Tighten the pressing device to hold the battery in place. If the pressing device is
tightened excessively, it will damage the battery box.
Tip
●
If the battery electrolyte is insufficient, must replace the battery; do not add the
electrolyte without permission.
●
If you leave the car, must close the doors and turn off all electrical devices.
●
If the car is placed for a long time, please disconnect the negative battery cable.
Note
●
When checking the battery, must remove the grounding cable from the negative
connector (with "-" mark) firstly and install it finally.
●
Must avoid short circuit when using a tool.
●
When cleaning the battery, do not to allow any liquid to enter the battery.