Table of Contents
Advertisement
Power over Ethernet (PoE) Class 3 — If PoE is available, the LEDs will turn on.
o
External Power — Connect an external 12 V DC or 24 V AC power source to the power
o
connector block.
6. Check that the Connection Status LED indicator indicates the correct state. For more information, see
Connection Status LED Indicator on
Initializing a Camera Username and Password
Cameras manufactured after January 1, 2020, do not have a default username or password and will be in a
factory default state.
Important: You must create a user with administrator privileges before the camera is operational.
The first user can be created using any of the following methods:
Camera's Web Interface: enter the camera's IP address in a web browser to access the web
l
interface. If the camera is in the factory default state you will be redirected to the Add a new user
page to create the first user. For more information, see the Avigilon High Definition H4 and H5 IP
Camera Web Interface User Guide.
Camera Configuration Tool version 1.4.4 or later: cameras discovered in the factory default state will
l
be identified by
the Avigilon Camera Configuration Tool User Guide.
USB Wi-Fi Adapter: when connecting a camera in the factory default state, you will be redirected to
l
the Create Administrator User page to create the first user. For more information, see Avigilon USB
Wi-Fi Adapter System User Guide.
Avigilon Control Center software version 7.4 or later, or version 6.14.12 or later: when connecting a
l
camera in the factory default state, the client software will ask you to create a new user. For more
information, see the Avigilon Control Center Client User Guide.
Avigilon Blue service v3.0 or later: when adding a camera you will be asked to create a new user for
l
cameras in the factory default state. For more information, see the Avigilon Blue Subscriber or Dealer
User Guides.
Tip: If you are connecting your Avigilon camera to a 3rd party VMS, you will need to set up the first
user through the camera's Web Interface, Camera Configuration Tool, or USB Wifi Adapter before
you connect to the 3rd party VMS.
(Optional) Using the USB Wi-Fi Adapter
If you have a USB Wi-Fi Adapter (H4-AC-WIFI), attach it to the camera's micro USB port to access the
camera's mobile web interface.
Initializing a Camera Username and Password
page 20.
. Select the Admin Users tab to create the first user. For more information, see
12
Advertisement
Table of Contents
