Wiring Diagram; Led Groups - Q-tran QTM-eLED+DALI-DT6-AN Manual

QTM-eLED+DALI-DT6-AN
LED POWER SUPPLY 100W–200W

Wiring Diagram

24VDC IN
*Internal to QTM unit
- +
D1+ D1+
D1- D1-
D2+ D2+
D2- D2-
DALI Signal in/out
•
Use these connectors when the driver is used in a DALI network. For DALI in, connect the network cable's DALI+, to the D1+, and D1- connectors
respectively. For DALI out, connect the network cable's DALI - to the D2+, and D2- connectors respectively.
•
Lutron Athena control system required. By others.

LED groups

•
Indicates the location of the connectors for your LED groups.The default group addressing can be changed over the 2-button user interface. For 2-wire
applications, 1(-) is wired to the - input on the terminal block.
© 2023 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@q-tran.com | www.q-tran.com
HOT
V-
V-
V+
V+
+
1(-)
2(-)
3(-)
4(-)
DALI
-
+24V
COMPLIANT
2-Wire
NEU
24VDC IN LED groups
DALI Signal
in/out
-
+
IN
NOTE:
2-Wire default is 1 address
For customization or pre-programming
contact a local sales rep.
DALI commissioning to be performed by
a third party at time of installation.
Specification subject to change. Rev-06-15-23