Q-tran QTM-eLED+DALI-DT6-AN Manual page 5

QTM-eLED+DALI-DT6-AN
LED POWER SUPPLY 100W–200W
Node And Conduit Entry Locations
RECESSED MOUNT
AN-1 AN-2
8.0"
4.0"
ISO VIEW
Conduit Entry Locations
Athena nodes must be installed on the secondary side of power supply center and require 1.0" of clearance
in order to optimally function. Metal conduit must be 1.0" away from any node. Refer to the diagram above
for recommendations for conduit entry into secondary compartment.
HORIZONTAL VERTICAL
SURFACE SPACING
9.5" O.C.
More Units can be stacked
© 2023 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | sales@q-tran.com | www.q-tran.com
SURFACE MOUNT
AN-1 AN-2
RECESSED MOUNT
19" O.C.
More Units can be stacked
SIDE VIEW
ADDITIONAL
KNOCKOUTS
Lutron Athena Node
Mounted in the secondary wiring compartment only
NOTE: Bracket can also be mounted
(Top & Bottom) for Vertical Mounts.
SURFACE STACKING
16" O.C.
COMPLIANT
16
SIDE
BOTTOM VIEW
0.875" KNOCKOUT 9X
(FOR 1/2" FITTINGS)
4.0" 8.0"
1/4"
Rod Thru Hole
3/8"
Rod Thru Hole
Double Sided
Key Hole
ROD SUSPENSION (Horizontal)
ROD SUSPENSION
Vertical
Plenum Door Required
Horizontal
NOTE: Rods not included.
Specification subject to change. Rev-06-15-23