Table of Contents
Advertisement
917X Series Metrology Wells
Safety Information
Symbol
1.3 Safety Information
Use this instrument only as specified in this guide. Otherwise, the protection provided
by the instrument may be impaired. Refer to the safety information in the Warnings
and Cautions sections below.
The following definitions apply to the terms "Warning" and "Caution".
●
●
1.3.1
Warnings
To avoid personal injury, follow these guidelines.
GENERAL
DO NOT use this instrument in environments other than those listed in the User's
Guide.
Inspect the instrument for damage before each use. DO NOT use the instrument if it
appears damaged or operates abnormally.
Follow all safety guidelines listed in this guide.
Calibration equipment should only be used by trained personnel.
If this equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
Before initial use, or after transport, or after storage in humid or semi-humid environ-
ments, or anytime the Metrology Well has not been energized for more than 10 days,
the instrument needs to be energized for a "dry-out" period of 2 hours before it can be
assumed to meet all of the safety requirements of the IEC 1010-1. If the product is wet
2
Description
Electric Shock
Fuse
OVERVOLTAGE (Installation)
CATEGORY II, Pollution Degree 2
per IEC1010-1 refers to the level
of Impulse Withstand Voltage
protection provided. Equipment of
OVERVOLTAGE CATEGORY II is
energy-consuming equipment to be
supplied from the fixed installation.
Examples include household, office,
and laboratory appliances.
"Warning" identifies conditions and actions that may pose hazards to the user.
"Caution" identifies conditions and actions that may damage the instrument
being used.
Symbol
Description
C-TICK Australian EMC mark
The European Waste Electrical
and Electronic Equipment (WEEE)
Directive (2002/96/EC) mark.
Advertisement
Table of Contents
