Table of Contents
Advertisement
The linkage frame (1) enables connecting the mower to the 3-point hitch of the tractor.
Drive from tractor rpm is transmitted through PTO shaft, intersecting axis gear (8) onto driving
shaft (7), which drives the cutterbar (4) through intersecting axis gear (9). Moreover drive from the
tractor rpm is transmitted onto
intersecting axis gear (9). On the cutterbar (4) there are discs with two cutting blades each.
Hydraulic lifting cylinder (2) fed from the tractor external hydraulics is used to adjust the mower to
working position. 3-point linkage frame, onto which spring suspended cutterbar is set (13). The
mower is also equipped with a rotational actuator (10), which has two functions. The first one is the
ability to fold the mower backwards which, in many cases, significantly simplifies transport, while
the second is the factory calibrated hydraulic safety device (11). On the 3-point linkage frame there
is safety guard (6) mounted. The crop guides (5) are installed on the upper cover of the scarifier.
Support foot (12) is mounted to 3-point linkage frame (1). Optional equipment: warning plate with
combined lights and reflectors (14).
12
Fig. 3b. Parts of SaMASZ rear disc mower with swath conditioner
1 – Linkage frame
2 – Lifting cylinder
3 – Swath conditioner
4 – Cutterbar
5 – Swath guides
6 – Safety guard
7 – PTO shaft I
Operating manual
(3) through intersecting axis gear (9), PTO shaft (7),
crop scarifier
2
1
11
10
14
8
7
(KT S/SL (H))
Rear disc mower with central suspension
- hydro-pneumatic or spring suspension
13
9
4
14
5
8 – Miter gear I
9 – Miter gear II
10 – Rotational cylinder
11 – Hydraulic safety device
12 – Support foot
13 – Spring suspension
Warning plate with combined
14 –
lights and reflectors
- 7 -
6
5
3
5
Advertisement
Table of Contents
