SaMASZ KT 261 SL Operator's Manual page 50

Calculating minimum weight of front ballast M
at rear and front:
Calculating minimum weight of rear ballast M
Calculating real axis load at tractor's front axis T
* If machine is mounted on tractor's front 3-point linkage (M
increase the weight of this machine to the required minimum load
Calculating total weight of tractor-machine assembly M
* If machine is mounted on tractor's rear 3-point linkage (M
increase the weight of this machine to the required minimum load
Calculating real axis load at tractor's rear axis T
Tire load capacity – apply double the load indicated by the tires' manufacturer.
ENTER THE ABOVE CALCULATION DATA AND TECHNICAL DATA PROVIDED BY
THE MANUFACTURER IN THE BELOW TABLE.
Minimum weight of
front or rear ballast
M or M
Pmin. Tmin.
Total weight
M
C
Front axis load
T
P rzecz .
Rear axis load
T
T rzecz.
Minimum ballast must be reached by mounting the machine or additional weights provided on the tractor.
Values resulting from calculations should be lower than or even to values given in technical specification.
Operating manual
Real value from
calculations
≤
≤
≤
Rear disc mower with central suspension
- hydro-pneumatic or spring suspension
– machine mounted at tractor's rear or
P min.
– machine mounted at tractor's front:
T min.
:
P rzecz .
) it is lighter than minimum required load at the front, so
P
:
C
) it is lighter than minimum required load at the rear, so
T
:
T rzecz.
Value to
technical
specification
≤
≤
- 4 8 -
Double value of
tire capacity
load