Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Atdec AWMS-DW6
Summary of Contents for Atdec AWMS-DW6
- Page 1 Dynamic Arm Post Clamp 60 Wall Channel (x1) (x1) (x1) CONTENTS 60 Wall Channel AWM-W6 Page 2 Component Checklist Page 3 Channel Installation Dynamic Arm AWM-AD Page 4 Component Checklist Page 5 Arm Installation AWMS-DW6 | Page 1 of 7...
- Page 2 IMPORTANT INFORMATION ! Please ensure this product is installed as per these installation instructions. ! This product is compatible with AWM Series products. ! The manufacturer accepts no responsibility for incorrect installation. AWMS-DW6 | Page 2 of 7...
- Page 3 Push knob to Tip: push knob aid insertion to aid insertion 3. Fit top cap to wall channel 3.1 Fit Top Cap Phillips Head Screwdriver Top Cap AWMS-DW6 | Page 3 of 7...
- Page 4 ! Curved monitors, deep devices (such as all-in-one PCs) and offset VESA locations exert additional leverage that can exceed the capacity of the mount even though the monitor weight may be within the stated range. Please contact Atdec if you would like further information.
- Page 5 4.1 Insert VESA head into the monitor arm 4.2 Ensure that the VESA head sits flush within 4.3 Push the lever down to secure the monitor arm. There should be no gap. it to the arm assembly Monitor arm No Gap AWMS-DW6 | Page 5 of 7...
- Page 6 When installing subsequent installation faster. monitors, pre-tension the arm to the recorded amount, then fine-tune the tension by Marker following steps 6.3 to 6.5. AWMS-DW6 | Page 6 of 7...
- Page 7 No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. ©20200402A AWMS-DW6 | Page 7 of 7 atdec.com | atdec.co.uk | atdec.com.au...
Need help?
Do you have a question about the AWMS-DW6 and is the answer not in the manual?
Questions and answers