Common Data For Modules - Danfoss AK-CC 750A User Manual

Common data for modules

Supply voltage
Power consumption
Analog inputs
On/off supply voltage inputs
Relay outputs
SPDT
Solid state outputs
Stepper outputs
Ambient temperature
Enclosure
Weight with screw terminals
Approvals
The mentioned data applies to all modules.
If data is specific, this is mentioned together with the module in question.
10
24 V d.c. / a.c. +/- 20%
AK-__ (controller)
AK-XM 101, 102, 103
AK-XM 204, 205, 208
Pt 1000 ohm /0°C
PTC 1000 ohm /0°C
Pressure transmitter type AKS 32R / AKS
2050 / AKS 32 (1-5 V)
Voltage signal 0-10 V
Contact function (On/Off )
Low voltage
0 / 80 V a.c./d.c.
High voltage
0 / 260 V a.c.
AC-1 (ohmic)
AC-15 (inductive)
U
Can be used for loads that are cut in and
out frequently, e.g. :
rail heat, fans and AKV valve
Used for valves with stepper input
During transport
During operation
Material
Density
Mounting
modules in100- / 200- / controller-series
EU low voltage directive and EMC require-
ments are complied with
RS8HP102 © Danfoss 2018-09
8 VA
2 VA
5 VA
Resolution: 0.1°C
Accuracy:
+/- 0.5°C (between -50°C and +50°C)
+/- 1°C between -100°C and -50°C
+/- 1°C between +50°C and +130°C
Resolution:1 mV
Accuracy +/- 10 mV
Max. connection of 5 pressure transmitters on one module
On at R < 20 ohm
Off at R > 2K ohm
(Gold -plated contacts not necessary)
Off: U < 2 V
On: U > 10 V
Off: U < 24 V
On: U > 80 V
4 A
3 A
Min. 24 V
Max. 230 V
Low and high voltage must not be connected to the same
output group
Max. 240 V a.c. , Min. 48 V a.c.
Max. 0.5 A,
Leak < 1 mA
Max. 1 AKV
20-500 step/s
Separate supply to stepper outputs : 24 a.c./d.c./ xx VA
-40 to 70°C
-20 to 55°C ,
0 to 95% RH (non condensing)
No shock influences / vibrations
PC / ABS
IP10 , VBG 4
For mounting on panel wall or DIN rail
Ca. 200 g / 500 g / 600 g
LVD tested according to EN 60730
EMC tested
Immunity according to EN 61000-6-2
Emission according to EN 61000-6-3
E31024 for CC-module
E357029 for XM and CM-modules
AK-CC 750A