Input Connections Diagrams; Saving Current Configuration (Memory Manager); Data-Logger - Presys TA-1200PLAB Technical Manual

PRESYS
 Instruments

2.1.2. - Input Connections Diagrams

2.1.3 - Saving Current Configuration (Memory Manager)

The TA Series calibrators admit several special functions that may become of
frequent use. In these situations, it is useful to store such settings in the instrument in order
to save time.
After setting the desired calibration mode (input type or special function), press the
→ MENU, and the button MEMORY MANAGER. On the option CREATE NEW
icon
can be given a name for this configuration and a description. Press the SAVE button.
The operation that was being performed by the TA Calibrator shall be stored in
memory identified by the name given to it. To use it again, even after the calibrator is turned
off and on, select the name of the desired setting and press the LOAD button. The SAVE
AS DEFAULT button sets the current configuration as the default configuration of the
calibrator. Thus, every time the calibrator is turned on, this will be the initial configuration
of the calibrator.

2.2 - Data-Logger

The TA Series Calibrators allow you to record a series of measurements over time
to display data in chart or table format.
Select CALIBRATOR from the main menu and select the desired configuration for
Probe and Input.
Press the icon
The calibrator automatically starts the measurements and displays each measured point
on the chart.
For measurements to be saved, you must press the REC button (see Figure 22).
With this option selected, all points (measurement and time) are saved in an internal file in
TA Calibrator, which can be used to generate a table or chart.
Page 14
Fig. 13 - Input Connections
and select DATA LOGGER.
TA-1200PLAB