Advertisement
Steam
en
Put the cover ‚ back into the opening on the water
7.
tank.
Insert the filled water tank (Fig.
8.
water tank locks into place behind both holders ƒ
(Fig.
).
&
Slowly slide the control panel downwards and then
9.
push it towards the rear until it is closed completely.
The water tank has been filled. You can start using
operating modes with steam.
Refilling the water tank
Notes
Steam-assisted operations continue without adding
■
steam.
If the water tank runs dry during the operation with
■
the Dough proving or Reheating settings, the
operation is interrupted. Fill the water tank.
Open the control panel.
1.
Remove and refill the water tank.
2.
Insert the filled water tank and close the control
3.
panel.
After every steam operation
:
Warning – Risk of scalding!
When you open the appliance door, hot steam can
escape. Steam may not be visible, depending on its
temperature. When opening, do not stand too close to
the appliance. Open the appliance door carefully. Keep
children away.
:
Warning – Risk of burns!
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
Caution!
Enamel damage: Do not start any operations when
there is water on the cooking compartment floor. Before
operation, wipe away the water from the cooking
compartment floor.
The remaining water is pumped back into the water
tank after every operation with steam. Then empty and
dry the water tank. Moisture remains in the cooking
compartment. To dry the cooking compartment, you
can either use the "Drying" operating mode or dry the
cooking compartment by hand.
20
). Ensure that the
%
Notes
Once the appliance has been switched off, the v
■
field remains lit for a little longer to remind you to
empty the water tank.
Remove limescale marks with a cloth soaked in
■
vinegar, then wipe with clean water and dry with a
soft cloth.
Emptying the water tank
Caution!
Do not dry the water tank in the hot cooking
■
compartment. This will damage the water tank.
Do not clean the water tank in the dishwasher. This
■
will damage the water tank.
Open the control panel.
1.
Remove water tank.
2.
Carefully remove the lid of the water tank.
3.
Empty the water tank, clean it with detergent and
4.
then rinse it thoroughly with clean water.
Dry all parts with a soft cloth.
5.
Rub the seal on the lid until dry.
6.
Leave to dry with the lid open.
7.
Place the lid on the water tank and push it down.
8.
Insert the water tank and close the control panel.
9.
Cleaning the drip trough
Allow the appliance to cool down.
1.
Open the appliance door.
2.
Soak up the water in the drip trough ‚ with a sponge
3.
cloth and wipe it carefully (figure
The drip trough ‚ is located below the cooking
compartment (figure
Starting drying
To dry the cooking compartment, it is heated up so that
the moisture in the cooking compartment evaporates.
You will then need to open the appliance door to allow
the steam to escape from the cooking compartment.
).
!
).
"
Advertisement
