Table of Contents
Advertisement
68012002065-HW
Chapter 7 : Advanced Features
Radio displays the playback status.
NOTE:
Received call overwrites the ongoing record playback. User can short press the
programmable button within three seconds to continue the playback and ignore the
receiving call.
User can short press the programmable button to trigger playback when the radio is
receiving call to overwrite the receiving call.
Playback can be halted by any tone and button press except for specific buttons. Check
with your dealer or system administrator for more information.
7.9
In-Call User Alert
This feature allows the radio to remain muted to affiliated talkgroup calls or dispatch calls while
operating on the current Trunking Personality or conventional channel respectively.
Group and individual Pages unmute the radio for the alert tone to sound. The radio also unmutes to
individual radio-to-radio calls. This feature is very useful when a radio-user prefers not to hear affiliated
talkgroup or dispatch calls traffic, but needs-to remain in radio contact. For an In-Call User Alert
enabled channel, the Voice Mute button-press or the Voice Mute menu-selection allows the radio-user
to toggle on and off Voice Mute functionality.
7.10
Quik Call II
This feature allows you to broadcast a series of distinct and recognizable tones before a voice
transmission from the dispatcher or a radio.
The broadcasting dispatcher or radio user can select this programmed Quik Call II tone transmission to
be sent to an individual talkgroup or over the entire system. Each tone is distinctive to indicate different
situation or different broadcaster.
NOTE: The receiving radio must be configured with the matching Quik Call II tone from the
transmitting radio, in order for the receiving radio to sound the selected tone followed by the
preconfigured alert tone.
7.10.1
Initiating Quick Call II Transmissions
Prerequisites: Tone must be preprogrammed into the Tone Signaling List on the broadcasting or
transmitting radio.
Procedure:
1
or to QCII, and press the Menu Select button directly below QCII.
2
or
to select the tone to broadcast.
3 Press the PTT to broadcast the selected tone, or press and hold the PTT to broadcast the
selected tone and transmit with your vocal transmission.
You hear the radio sounds the selected tone. You can begin your call after the tone ends.
4 Release PTT to listen.
70
Advertisement
Table of Contents
